Skip to Content
Water Pressure Monitoring

See the pressure.
Before the calls.

Add a pressure sensor to the Tesla Duo and get high and low pressure alarms in Tesla MDM, on the same network that reads your meters.

Water and GasHigh / Low AlarmsText AlertsMulti-Network
ZONE 3 · MAIN LINE · PSI HIGH LIMIT LOW LIMIT PRESSURE LOW Text sent to your crew Pressure from the field, alarms in Tesla MDM.
Instant
alarm when a reading crosses your limit
2
limits you set: high and low
0–232
psi sensor range
1
network for meters and pressure
What it catches

Pressure tells the story.

Main breaksA sudden drop in a zone points to water leaving the pipe.
Pump troubleInlet and outlet readings show if a pump is starved or falling short.
High pressureCatch a failed regulator before it strains mains and customer plumbing.
Low pressureLow pressure raises the risk of contamination getting into the system.
Fire flowKnow the pressure in your outlying areas before you need it.
Pressure historyEvery reading logged in Tesla MDM for reports and regulators.
Where it goes

Four places that matter.

1
Pump stationsBefore and after each pump.
2
Tank outletsEnough pressure leaving to reach the far end.
3
Zone entry pointsDrop inside a zone, not outside? The problem is in there.
4
Dead-end mainsLow pressure shows up here first.
How it works

Three steps.

1
Tap the line

Set the sensor where you want to watch pressure.

2
Plug into the Duo

The Tesla Duo has a second port for a pressure sensor.

3
Set your limits

Tesla MDM alarms immediately when a reading goes high or low, and texts the staff you choose.

Gas systems tooTesla MDM alarms high and low pressure on gas. Watching gas lines and regulator stations? Gas Pressure Monitoring
Pair it with a shut-off valveThe same Duo port family runs a five-position valve at the meter. Remote Shut-Off Valve
Questions

Pressure monitoring FAQ.

How does RG3 pressure monitoring work?

A pressure sensor connects to the second port on a Tesla Duo endpoint. The Duo sends pressure readings over the Multi-Network to Tesla MDM, which raises an alarm immediately when a reading goes above or below the limits your utility sets.

Where should pressure sensors be installed?

Common spots are pump station inlets and outlets, storage tank outlets, the entry points of pressure zones, and dead-end mains where low pressure shows up first.

Who gets the pressure alarms?

Alarms show in Tesla MDM, and your utility chooses which staff also get a text when pressure goes high or low.

Does it work on gas systems?

Yes. RG3 also offers gas pressure monitoring with the same high and low alarms in Tesla MDM. See the Gas Pressure Monitoring page.

Know your pressure.
Before your customers do.